NTOPNG START GEOIP LICENSE KEY
NTOPNG START GEOIP INSTALL

17:41:17 nprobe.c:7035 nProbe started successfully > I can see packets coming in. sudo mkir /etc/ntopng -p sudo -e /etc/ntopng/ntopng.start -local-networks '192.168.1. The geoip list must be enabled manually: config setprop geoip status enabled signal-event nethserver-blacklist-save geoips Once downloaded you can enable the geo banning by the command line: config setprop geoip status enabled Categories es,fr Whitelist 195.234.41.0/24,195.234.42. I assume that 192.168.1.0/24 is the CIDR address prefix of your local network.

The transition is pretty straightforward: there is nothing special to do, and everything will continue to function automatically and transparently once you have obtained a license key. Im sending NetFlow data to port 2055 on the nProbe/nTop host. Download the ntopng zip file from the link above, locate it in the filesystem, and unzip it to access the actual ntopng installer. After building ntopng, create a configuration directory for ntopng, and prepare default configuration files as follows. rootlocalhost ntopng make geoip - 17:06:35.

NTOPNG START GEOIP INSTALL

Package ntopng-data continues to exist, however, it no longer carries databases but just the MaxMind download helper geoipupdate which fetches databases from MaxMind servers using the license key.ĭetailed instructions to continue using geolocation databases in ntop products are available here. To begin with the installation procedure, install the dependency packages for ntop by.

NTOPNG START GEOIP LICENSE KEY

Hence starting late December 2019, in order to continue using geolocation in ntop software, you are required to register for a MaxMind account and obtain a license key in order to download geolocation databases. Reasons are the same that have impacted MaxMind ability to do the redistribution and are explained in detail at the following page. Unfortunately, new privacy regulations, such as GDPR and CCPA, place restrictions that impact our ability to continue distributing databases in ntopng-data. To add VLAN subnet, we can use -m option. The number of interfaces comes from your available eth on your server, where ntopng is installed.

On ntopng.start file, we can put the local-network parameter more than 1. ntop have been freely packaging and redistributing such databases in ntopng-data. Ntopng can monitor more than 1 IP address. Ntop products have been using geolocation databases provided by MaxMind for a long time, to augment network IP addresses with geographical coordinates (cities, countries) and information on the Autonomous Systems.

Ntopng start geoip