The veneer will extend about 2 feet from grade above the wall will have EIFS installed over the CMU backup. The masonry wall s are to have a cavity wall of 4 -inch architectural CMU veneer with a CMU backup. Figure 8-34 shows three typical metal ties.I just left a meeting with a mason and an architect where we had a discussion on mortar types. When a wall bond has no header courses, use metal ties to bond the exterior wall brick to the backing courses. These joints center on the headers in the courses above and below. It differs only in that the joints between the stretchers in the stretcher courses align vertically. The English cross or Dutch bond is a variation of the English bond. In large wall areas or load-bearing construction, insert steel pencil rods into the horizontal mortar joints as reinforcement. This pattern usually bonds to the backing with rigid steel ties or 8-inch-thick stretcher units when available. You can vary the pattern with combi- nations and modifications of the basic patterns shown in figure 8-33. You must use dimensionally accurate or carefully rematched units to achieve good vertical joint alignment. The stack bond is purely a pattern bond, with no overlapping units and all vertical joints aligning. You can use blind headers in courses that are not structural bonding courses. However, the joints between stretchers in all stretcher courses do not align vertically. The headers center over and under the stretchers. The English bond consists of alternating courses of headers and stretchers.

In the English corner, a 2-inch or quarter closure starts the course. In the Dutch corner, a three-quarter closure starts each course. You can start the corners in two different ways. When headers are not required for structural bonding, you can use bricks called blind headers. The joints between stretchers in all stretcher courses align vertically. The headers in every other course center over and under the stretchers in the courses in between. In the Flemish bond, each course consists of alternating headers and stretchers. In a common bond, use a three-quarter closure at the corner of each header course. In laying out any bond pattern, be sure to start the corners correctly. You can vary the common bond with a Flemish header course. Header courses usually appear at every fifth, sixth, or seventh course, depending on the structural bonding requirements. The common, or American, bond is a variation of the running bond, having a course of full-length headers at regular intervals that provide the structural bond as well as the pattern. The running bond is used largely in cavity wall construction, brick veneer walls, and facing tile walls made with extra wide stretcher tile. Because the bond has no headers, metal ties usually form the structural bond. The running bond is the simplest of the six patterns, consisting of all stretchers.

Figure 8-33 shows the six basic pattern bonds in common use today: running, common or American, Flemish, English, stack, and English cross or Dutch bond. The pattern may result from the structural bond, or may be purely decorative and unrelated to the structural bond.

Pattern bond refers to the pattern formed by the masonry units and mortar joints on the face of a wall. Mortar bond refers to the adhesion of the joint mortar to the masonry units or to the reinforcing steel.

Using grout to adhere adjacent wythes of masonry.

Masonry stack bond